YOUR STORY PLAYS HERE
Home » Categories » General » Nerd Stuff

Setup Windows 2008R2 as an NTP server

 

  1. Click Start, click Run, type regedit, and then click OK.
  2. Locate and then click the following registry entry: HKEY_LOCAL_MACHINE\SYSTEM\CurrentControlSet\Services\W32Time\Config\
  3. In the right pane, right-click AnnounceFlags, and then click Modify.
  4. In the Edit DWORD Value dialog box, under Value data, type 5, and then click OK.
  5. Enable NTPServer.
    1. Locate and then click the following registry subkey: HKEY_LOCAL_MACHINE\SYSTEM\CurrentControlSet\
                                                      Services\W32Time\TimeProviders\NtpServer\
    2. In the right pane, right-click Enabled, and then click Modify.
    3. In the Edit DWORD Value dialog box, type 1 under Value data, and then click OK.
  6. Exit Registry Editor.
  7. At the command prompt, type the following command to restart the Windows Time service, and then press ENTER: net stop w32time && net start w32time
0 (0)
Article Rating (No Votes)
Rate this article
  • Icon PDFExport to PDF
  • Icon MS-WordExport to MS Word
Attachments Attachments
There are no attachments for this article.
Related Articles RSS Feed
How to define what version of SMB to use when connecting to a SMB share from a MacOS Client
Viewed 1130 times since Mon, Jul 25, 2016
How to Factory Restore a Carousel 260
Viewed 1422 times since Thu, May 4, 2017
How do I check my populated RAM slots
Viewed 988 times since Mon, Jun 15, 2015
Matrox Convert DVI Power Supply
Viewed 2401 times since Mon, May 4, 2015
Network interface binding for Cablecast Device Control
Viewed 1435 times since Wed, Dec 14, 2016
How do Tightrope’s Versions relate to each other
Viewed 1123 times since Mon, Dec 22, 2014